Construction log of my RV-9A fuselage
Archives
10/01/2003 - 10/31/2003
11/01/2003 - 11/30/2003
12/01/2003 - 12/31/2003
01/01/2004 - 01/31/2004
02/01/2004 - 02/29/2004
03/01/2004 - 03/31/2004
05/01/2004 - 05/31/2004
06/01/2004 - 06/30/2004
07/01/2004 - 07/31/2004
08/01/2004 - 08/31/2004
09/01/2004 - 09/30/2004
10/01/2004 - 10/31/2004
11/01/2004 - 11/30/2004
Current Entry
Home Page
Build hours: 404
10/01/2003 - 10/31/2003
11/01/2003 - 11/30/2003
12/01/2003 - 12/31/2003
01/01/2004 - 01/31/2004
02/01/2004 - 02/29/2004
03/01/2004 - 03/31/2004
05/01/2004 - 05/31/2004
06/01/2004 - 06/30/2004
07/01/2004 - 07/31/2004
08/01/2004 - 08/31/2004
09/01/2004 - 09/30/2004
10/01/2004 - 10/31/2004
11/01/2004 - 11/30/2004
Current Entry
Home Page
Build hours: 404
RV-9A Fuselage Construction
Tuesday, November 02, 2004
Reply from Van's RE: panel position
I must have caught the tech support guys at a slow time.. only took them 1.5 hrs to reply to my email. Normally takes a day or two.
====
The hole in the panel should be about 7/16 from the bottom edge.
With the 5/16 dim on the angle (721C) that = 12/16 or 3/4, ie the width of the angle, so the clearance between the panel and the 721A should be minimal, but .020 would be OK. I'm not sure why the math isn't working out for you if the panel is punched correctly, unless the angle is 1"? (Guss)
====
Comments:
Post a Comment
