Details the construction of my RV-9A wings.
Archives
05/01/2003 - 05/31/2003
07/01/2003 - 07/31/2003
08/01/2003 - 08/31/2003
09/01/2003 - 09/30/2003
11/01/2003 - 11/30/2003
12/01/2003 - 12/31/2003
01/01/2004 - 01/31/2004
02/01/2004 - 02/29/2004
03/01/2004 - 03/31/2004
04/01/2004 - 04/30/2004
05/01/2004 - 05/31/2004
06/01/2004 - 06/30/2004
10/01/2004 - 10/31/2004
12/01/2004 - 12/31/2004
Build Hours: 280
05/01/2003 - 05/31/2003
07/01/2003 - 07/31/2003
08/01/2003 - 08/31/2003
09/01/2003 - 09/30/2003
11/01/2003 - 11/30/2003
12/01/2003 - 12/31/2003
01/01/2004 - 01/31/2004
02/01/2004 - 02/29/2004
03/01/2004 - 03/31/2004
04/01/2004 - 04/30/2004
05/01/2004 - 05/31/2004
06/01/2004 - 06/30/2004
10/01/2004 - 10/31/2004
12/01/2004 - 12/31/2004
Build Hours: 280
Current Entry
Fuel Tanks
Fuselage
Home Page
RV-9A Wing Construction Log
Wednesday, June 09, 2004
J-stringers, replacement rivets and stuff....
I drilled out some skin rivets that needed replaced and a row of rivets on the rear spar that were severely over-set. I put the j-stringers in place and have rivets in, taped and ready to go.
I fussed with the fit of the fuel tank on the spar a bit. Also put in some rivets on the main spar where the leading edge ribs would normally go but only where there was a spar doubler. I drilled the tie-down hole as well.
I'll get Sandi out to help me set the remaining rivets and then it's on to the bellcrank and gap fairings.
I haven't had a photo in awhile.. so here's a shot of the right wing. Shop is a mess.
(Time: 1.5 hours)
